ST-Link V2 ST-Link Mini STM In-Circuit Programmer and Debugger for STM8 and STM32 – with Cover

Description:
Mini ST-Link V2 is a low-cost solution for in-circuit debugging and programming of STM8 and STM32 microcontroller series. This device will surely come handy whenever you come across the highly popular STM microcontroller.

It comes in one USB stick protected by an aluminum enclosure with cap and accompanied with a 4-way female-female jumper wire. Its DFU bootloader enable necessary firmware update to support more devices in the future; just unplug/replug USB to kick off the DFU process. It even has dual voltage output (3.3V/5V), for easy debugging/programming. A definite must-have for all programming enthusiasts!

Features:
Programming supports FLASH ROM, EEPROM, AFR, etc.
Debugging run at full-speed, single-stepped, breakpoints, viewing variables and registers, etc.
USB interface for direct connection to PC
USB 2.0 full-speed-compatible
Upgradable firmware
Automatic firmware upgrade from official ST-Link software
On-board 500mA internal resettable fuse for short circuit protection
Dual voltage output (3.3V/5V)
Red and blue LED indicator, blinks during communication with the PC
20cm 4-way female-female jumper cable

Supported Software:
ST-LINK Utility v2.0 (or higher ver.)
STVD Version 4.2.1 (or higher ver.)
STVP Version 3.2.3 (or higher ver.)
IAR EWARM Revision v6.20 (or higher ver.)
IAR EWSTM8 Revision v1.30 (or higher ver.)
KEIL RVMDK Revision v4.21 (or higher ver.)

Supported Devices:
All the STM8 devices with SWIM interface
All the STM32 devices with SWD interface

Specifications:
SWD Voltage Range: 1.65V – 3.6V
SWIM Voltage Range: 1.65V – 5.5V
SWV Support: None
Debug Interfaces: 2
LED indicator: Dual color LED (Red and Blue)
Fuse: 500mA resettable fuse

Contents:
1 x ST-Link V2 ST-Link Mini
1x 4-way female-female jumper wire